В колонках играет - The Hollies - Clown
Настроение сейчас - настроенноеCunning Hat Pattern:
Materials-
For the hat in the picture, I used single ply, bulky yarn in three colors. I have seen excellent results that used 2 strands of worsted, and that may be the better choice.
I humbly present the colors I used for orange, yellow, and rust respectively:
Lamb's Pride bulky, colorway "Orange You Glad"
Lamb's Pride bulky, colorway "Wild Mustard"
Mirasol Sulka, in the cunningly named shade, "208." (This is a single ply, bulky yarn, despite Ravelry's insistance that it's a 10-ply Aran.)
Circular size 10 US needles (No dpns required.)
Tapestry needle
Pompom maker or cardboard circles.
Gauge: 3.5 st/in; 4.5 rows/in.
(Note: Ideally, I would like to knit this over 54 st with size 10.5 or 11 circs, but I don't have the needles yet. Pattern may be updated later to reflect ideal hat.)
With orange, CO 60 with Twisted German. (For larger sizes, just add 4 stitches for approximately every inch larger than 21" you want it, totaling any multiple of 2.)
Join, with yarn on right needle, being careful not to twist. Place stitch marker. Replace stitch marker with scrap yarn or coil-less safety pin on the next round.
Round 1: K1, p1 around (60 st).
Round 2: (K1, p1) 22 times (44 st). Place 2nd stitch marker (replace later as with first marker). This is the new beginning of the row.
Flip the hat inside out and turn the needles around. You will now be knitting over what you just knit, instead of proceding to stitches you haven't ribbed a second time. This adds height to the sides of the hat without adding it to the front, which is designated as being the short distance between your stitch markers. I suspect Ma Cobb put the hat down to rest her hands, and when she picked it up, she didn't know where she left off.
Round 3-11: Knit around (60 st). (Height should be approximately 2 1/2" in front, and 3" on sides.)
Round 12: Join yellow yarn and k2tog for first st. Knit around (59 st).
Round 13- 37: Knit around (59 st).
Cut yarn 12" long, thread onto tapestry needle, and weave through all loops. Pull closed to form gather. On WS of hat, run yarn around the gather a few more times and fasten securely. Leave end hanging inside WS of hat; do not weave in.
Earflaps:
Row 1:(RS) Pick up 15 stitches beginning with the stitches directly after your stitch marker. Join rust yarn, knit across. (15 st.) (For larger sizes, pick up 17 instead of 15 stitches, then 2 more for every 2 extra inches you've added. For example, if you're making a 22-23" hat, pick up 17. If you're making a 25" hat, pick up 19.)
Row 2: (WS) Knit across (15 st.)
Row 3: Knit across
Row 4: Purl across
Repeat rows 3 and 4 until flaps measure 5", then begin decrease rows:
Decrease row (RS): K1, ssk, knit to last 3, k2tog, k1.
Decrease row (WS): P1, p2tog, purl to last 3, p2tog, p1.
Repeat decrease rows until 3 st remain. Pull yarn through all three loops.
Add yarn to create three ends. I threaded a needle, stuck it in near the the existing end, left an end out, then wove the needle's yarn up and down the dreased edging, before pulling the yarn out next to the other two ends. Tie the thre ends together in a series of three knots.
Repeat ear flap for other side.
Create pompom for hat, using mostly rust with only some orange and a tiny bit of yellow. Thread the two ends from the pompom's tie, and insert needle into top of hat. Pull yarn through to WS. Weave the ends in on the WS, and securely fasten to the existing yellow end.
Wear hat.
How's it sit? Pretty cunning, don't ya think?
Keiyla Renee (c)
Enjoy, если сможете. Keep smiling.
1.
2.
3.
4.
5.
6.
1.