Three.  A piece of cardboard (preferably white) to cut out A Small Circle of diameter, calculate the diameter of Approximately 10 centimeters.

4.  1.0 A wire with white ribbon teip, it Turns out 8 halves, then there Should be four integers.  You CAN use skewers Also, if you want the spokes on an Umbrella is not bent and it Could be put to One Side.

Five.  Cable, such That A well-bent and fixed, are They Different, this is 0.96 centimes per meter, bought in the DEPO, we need to be 38 centimeters (by trial and error I realized that this length is ideal) - 1 cm in diameter

6.  Lace, One to Hide the seams of the Upper, the Other (But CAN be the Same) on the Edge, Look to Combine with the main color of the Umbrella, plus, if They are on the Edges and seams are Different, then it is Also Necessary so That it is combined and the texture and color. 
On the Edge of leaves About 1.20 m in the middle of A Take stock of 2.0 meters

7.  Satin ribbon width Slightly greater than 1 cm, the length of this to wrap the cardboard circle, well, take a meter 3, 4 can be, just in case.

Eight.  Organza ribbon, wrap the leg Beautifully Umbrella, See That, again, Match the color, it Should be About Three and A half feet.

A.  First, Take the Cable and wrapped around His white (in Our Case) teip tape, shakes very Carefully.  Tip One of the Cable Beautifully wrapped Will be, Will it bend, and the Second we Leave A length of 1.5-2 About cm for pasting into a cone.

Two.  swathes of satin cord, ribbon or Any Other, in Other words, Decorate it, Sometimes A bit of glue drips, Fix.

3.  Take the foam cone, Scissors, done A little hole for the Cable (in the Wider Part of the cone) and glue A piece of Cable, we Decorate.

4.  Cut out flat cardboard Circle with diameter of A About 10 cm, making it the middle of the hole diameter of 1 cm (for Cable). Our Circle of swathes of beautiful ribbon.

Five.  very Carefully threaded through the Cable Circle and glue to the cone.

6.  Take Our eight halves of the wire (or skewers), wraps Them teip tape.  On the One Hand beautiful Finish, and the Second, Which Will we paste into the cone, you CAN not wrap an inch and half A.

7.  At this stage we need to paste Will Our wire crosswise (or spokes in the Umbrella) in the cone.  In order to Ensure That They pasted EXACTLY, we need to measure the first One - to what we PLACE Will paste - Mark marker and Mark it on the Other seven, then we have an Umbrella spokes are Equal length.  Moreover's, the paste must be so That They do not touch the Cable, That is, not very deeply into the cone.  Plus, we do it at Almost the Base, Almost immediately on cardboard Our Circle. (This is done so That When we Look at Our Umbrella from the bottom, the spokes Would be neat, Close fit with the cardboard and there WAS A hole.)

8.  Getting the Most laborious work, Measured and glued the fabric on the spokes. Immediately Decide Whether to stick your Umbrella tips of needles or not - depends on how you glue the Sector Will - or in Whole, or not reaching the Edge.  As for gluing say A few words.  I do so - enclose A piece of fabric, Needle stick gently (See That the glue WAS not visible from the bottom, Remove the excess drops at once), then cut, and so each Sector. That is , I do not cut the pieces at once - first stick, and then I cut.  Try it, maybe you Get A Different way.