Created by-Martin Purcell

A collection of tips on how to be successful at plumbing makes the perfect starting point for a beginner. Below is just such a collection that will hopefully assist the eager novice into eventually becoming a pro when it comes to plumbing.

Act quickly if your pipes freeze! Shut off the water and open the faucet, enabling it to drain when it thaws. Starting with the faucet, and working your way to the iced-up area, aim a propane torch or hairdryer at the pipe - this will quickly defrost it. You could also wrap the pipe in a heating pad or aim a heat lamp at it, but this will take quite some time. A last resort is to wrap the pipe in rags and pour boiling water over it.

Rigid copper is used for main water lines in many homes. You cannot bend rigid copper, so joints and tees must be soldered on. When soldering, always apply flux (also called soldering paste) to both surfaces. Flux retards oxidation when the copper is heated. Always use lead-free or nearly lead-free solder when sweating a copper joint.

Flush your drain with a constant stream of cold water when operating your drain mounted disposal unit. When cold water hits the garbage disposal, it sharpens the blades. This keeps the disposal working properly. Avoid using hot water, as this will liquefy grease, causing it to build up in the drain and obstruct your pipes.

Do not put your hand in the garbage disposal to remove a clog. This can be potentially harmful. Always use tongs to get out whatever is stuck in the disposal. Using tongs is much safer, and you will make sure your hand does not get cut on the disposer's sharp blades.

At least once a year remove the faucet aerator and clean the screens. This helps it properly function. The function of a faucet aerator is to allow for an even flow of water and to conserve water. Be sure to clean out the aerator and you'll notice a these things working.







If you live in an area that sees routine freezing temperatures, make sure you do something to keep your pipes from becoming frozen as well. There are a wide variety of ways you can keep your pipes from freezing, which will help you avoid damage to your home and costly repairs.

Drain the sediment from the bottom of your hot water heater twice a year to keep the hot water heater working at its optimal levels. Simply open the drain valve and allow the water to run out into a bucket until the water runs clear. Then close the drain valve.

A sewage backup into the toilet is caused by problems often deep within the sewage line. If you have tried and cannot remove the blockage, you will need a plumber to come to your home and run the plumbing snake down into the toilet to clear the blockage.

Treating your drains every month is a great way to avoid future clogs and other problems, and it's a very simple procedure. Just run one to two gallons of hot tap water down each drain in your house.

Governmental regulations sometimes prevent plumbers from actively providing maintenance to copper piping. If you have a calcium buildup in your copper piping, you are going to need to take care of this yourself. just click for source have to get rid of all the water and add vinegar which eats away the calcium buildup out of copper pipes.

Be sure that you check on your water meter when it is not being used. Then, check on the meter 8 hours later. If the meter has changed, even a small amount, this could be a sign that there is an undetected water leak, which can be a severe problem.

The dryer has a lint trap that must be kept clean. simply click the following article can prevent various problems, including a fire. Be sure to inspect the lint screen for any tears or holes. That could result in lint traveling down your pipes, and that may result in clogs and other issues that have to be dealt with.

Having to wiggle the toilet handle or hold it down to get your toilet to fully flush indicates that the tank parts need to be replaced. Kits that include all of the parts needed can be purchased in any hardware or home improvement store to easily do the repair yourself.

It is a general rule of thumb that you should replace a water faucet every seven years, even if you do not see anything wrong with it. Some faucet problems are not visible to the naked eye, which is why it is so important for them to replaced every so often.

When you are working on any kind of plumbing project, you always need a backup person. This is because, when working with water, you never know when an emergency can happen and that second pair of hands can come in very useful! This can even be an unskilled person who can follow directions.

If you have infrequently used drains in your house, you should pour water into them on a regular basis. This water will fill the trap and will prevent odors from entering the house. If you have slow floor drains, you should snake them to ensure they are capable of carrying water away quickly in the event of a flood.

If your water bill seems unusually high and you haven't changed your water usage, the problem is most likely in the service line. The cost to hire a professional to find and repair the service line most often is far greater than installing a new line and then having the old one shut off permanently.

Keep water trickling slightly from faucets to help prevent frozen pipes when the temperature drops significantly. Colder than normal temperatures can cause problems if pipes are not insulated appropriately, even when pipes are not exposed to the elements. By leaving the water running slightly, you keep movement in the pipes which can prevent freezing.

To summarize, you want to know that you are taking care of your plumbing job just the same as a professional would, but without the additional costs they would inflict upon you. Hopefully, this article was informative enough for you to tackle any plumbing issue that might come your way.