To repair a kitchen faucet cartridge, you need to first disassemble it. This is a relatively easy task. First, unscrew the retaining nut under the cartridge. Then, unscrew the cartridge stem, handle, and disk cylinder. In some cases, you may also need to remove the neoprene seal. Then, clean the cylinder openings with distilled white vinegar or a soft scouring pad.

Install the new cartridge

To remove the cartridge, unscrew the brass screw that is secured in the faucet's body. You may need to use pliers to push it down. You must also line up the two notches in the new cartridge with the rivets on the faucet body. Next, install the new cartridge by aligning it with the old one. After you have removed the two retaining clips, you can pull the cartridge from the faucet's body. Some faucets have a brass nut holding the cartridge in place. If you're unable to do so, you may need a special tool to do the job. In some cases, you may also need a brass nut to rebuild the faucet.If you've noticed water leaking from your faucet, it's probably a worn-out faucet cartridge. This usually happens when debris has accumulated in the water supply lines. If the water supply lines are dirty, this can also cause a leak. To repair a black kitchen tap cartridge, follow these simple steps.

Replace a kitchen faucet cartridge

To replace a kitchen faucet cartridge, you first need to remove the leaking cap. Use an Allen wrench to remove the cap. Once the cap has been removed, two plastic rings will be exposed. The damaged rotary ball should be removed with the help of an Allen wrench. You can buy a replacement at a hardware store.The Ashfield 26 series faucet has two styles. One style was released in 2006, while the other style was released later. For both styles, it's important to measure the cartridge. In the "old style," the cartridge is 35mm in diameter; in the "new style" style, the cartridge is 25mm in diameter. The water shutoff valve is located under the sink and is a small football-shaped handle with a rotating lever. To shut off the water supply, you need to turn the handle clockwise. In other models, you can turn the lever in the same way as the water line. Afterwards, reassemble the faucet and tighten the parts. If this does not solve the problem, you may need to replace the faucet cartridge.