or these earrings, Jeanne used size 80 thread. Wind 2 shuttles with choice of colors. If using 2 colors, shuttle 1 is the outside color and shuttle 2 is the inside color. You could use a single color, but the petal definition won’t show up as well. Knot ends of threads together leaving a 10" - 12" tail on shuttle 2. Hide the end of shuttle l’s thread in the first ring, leaving the long tail of shuttle 2 loose until the end.

Thread a needle with the end of shuttle 2 beginning tail. Thread this tail through the picot on the bottom side of each ring. Start spiraling rings as you thread them on the needle making sure you go through each picot in the same direction. Pull the thread tail up tight continuing to spiral the rings. Hold the rose tight together while knotting this thread. Then tie the ends left after the 25^th ring to one of the other rings so that the end ring isn’t "flopping loose."

This rose can be glued to earring backs or attached to other findings or if you don’t cut the thread tails tat over them inserting wire to make stems for flowers.