Article by-Watkins Riis

There may come a time when you have issues with your plumbing, whether it's a clogged sink or plugged up toilet. Check out the tips and suggestions in the article below that will show you easy things you can do on your own to solve these issues, and save a call to a plumber.

Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.

Use a hairdryer to thaw frozen pipes, after you shut off the water to the house. A hairdryer will gently heat the pipe and thaw the ice without causing significant damage to the pipe. Shutting off the water first means that if the pipe is broken, there will be no rush of water into the house.







If the water in your toilet is low along with the toilet being clogged, pour some extra water in the bowl to make the plunger effective again. Repeat this as many times as necessary until your clog is gone, and you can flush normally once again.

Basic problems with toilets can be a quick fix for even the rawest amateur plumber and is worth attempting if you can take the time to research the problem. Seek out the necessary part or parts from your local hardware store and ask for support in how to properly install them.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide https://www.whbc.com/dont-flush-this-warnings-about-your-plumbing-and-the-sewer/ of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

It is important to know how to properly anchor your pipes when it comes to plumbing. This is extremely important to know because not having your pipes well anchored could result in loud noises, leaks, or pressure problems. Call a professional if you are unsure how to take care of it yourself.

When chilly weather approaches, it is time to disconnect your water hoses from your outside faucets. If you forget to do this, water in the hoses can freeze and expand. This can cause the faucets and the connecting pipes inside your house to freeze and break. By simply rolling up your garden hoses and storing them for the winter, you can help prevent costly plumbing repairs.

Never hire a plumber that is not licensed, insured and bonded. If the plumbing company cannot provide you with reference numbers for their credentials, move on quickly. It is a common question and it should be a no-brainer for them to provide them to you. If they have issues with you asking, take that as a big red flag.

If your plumbing is making strange noises you may have lost something called your "air cushion". To turn this back on, you're going to need to turn off your main water supply. Run all faucets in your house and then turn back on your main water supply. This should make everything sound better again.

Periodically, make sure that the sump pump in your house is working to full capacity. Pour a few gallons of water into the sump pit, and your pump should drain that water out with minimal issues. Checking that your devices are working throughout the year can pay large dividends in the event of a crisis.

To lessen the amount of hair going into your home plumbing, thoroughly brush hair and use a body brush to remove loose body hair before entering the shower or bath. If it's been a while since you have shaved your legs or face, use an electric razor to remove the longer hair, before shaving in the sink or shower.

In any DIY plumbing project, make sure that you always test the drains and the supply lines before you close up the walls. It is a lot easier to find and solve problems if you look for them while you are still in the process of actively doing the job.

A water heater that has no tank is a good choice for those that are conservation-minded. They work differently than conventional water heaters because they don't store water and heat the water only as it is needed. A number of dollars are saved off of power bills because unused water is not heated just to sit around.

When you are going to do laundry in your home washing machine, do not use excess detergent, bleach or other chemicals. Too many of these products can cause the natural bacteria in your septic system to be killed. Just use enough of these products in order to get your laundry done.

Is your shower pressure weak due to clogging of the openings in your shower head? Here is a simple and cost-effective tip to take care of that problem. Pour a cup of vinegar into a plastic bag, place it over the shower head, and twist tie it into place so it can soak overnight. In the morning, remove the plastic bag and use an old toothbrush to scrub off the mineral deposits which are clogging the openings. This will help to restore water flow and increase shower pressure.

When it comes to plumbing an ounce of prevention is the best thing to prevent things from going haywire. In order to prevent clogging avoid doing things that would clog drains. Do not pour http://asialogue.com/news/midwest-plumbing-indiana...cy-critter-situations/0276438/ down the kitchen sink, and install hair catching filters in all your bath tubs. This will prevent a lot of unnecessary clogs.

Buying plumbing tools might seem expensive, but they could save you a lot of money. Scour the web and look at basic plumbing repair videos to see what you might need. If you invest in the right tools, you will not have to call a professional plumber for any minor problems you run into.

Take a look at your tiles for evidence of damage from a water leak. Loose tiles could be an early sign that leaks have caused damage, so press against tiles gently to see if they "give". Consider loose tiles to be an early warning system so you can schedule a repair right away.

As you can see, there's no reason to pay so much just to wait for a plumber to come and fix a problem that you could be working on yourself. Applying the tips in this article can save you time and money next time your plumbing needs to be repaired.