Written by-Bradford Buur

Were you aware that winterizing your plumbing system is nearly free and can save you potentially thousands of dollars of repairs. If this advice sounds appealing to you, then be sure to check out more of the expert advice given in this article. You will be much happier than if you had to deal with a water crisis during the middle of winter.

Solder with safety in mind. When you solder a copper pipe you want to direct the flame on the copper pipe. The flame of the torch has to be four inches away from the piping. The flame should be targeted directly at the point where the copper piping needs to be disconnected.

Make sure you know where your home's water shutoff is located. You never know when there might be an emergency involving a broken pipe or damaged connection that requires you to turn off the water right away. In addition, knowing where the shutoff is located is vital before you start any plumbing project, in case anything goes wrong.








You should drain all of the water out of the tank of your hot water heater at least once every three to six months. Draining all of the water out of the tank helps to prevent sediment build-up at the bottom of the tank. This sediment can cause the tank to bang or to heat less efficiently.

Avoid using simply click for source on your toilets, such as drop-in cleaner tabs in the tank. When these tabs are almost completely dissolved, what's left of the tab gets washed into the bowl. This can then end up clogging the toilet's port holes, preventing the toilet from flushing properly. It can take months for this debris to finish dissolving in those holes.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

If you have a crack in your toilet tank, you can sometimes fix this with an epoxy resin. However, http://timika80rick.blogminds.com/pipes-101-tendin...ur-pipeline-like-a-pro-3801789 is very difficult to keep up with this type of maintenance, and the best bet may be contacting the supplier and ordering a new tank to be installed in your bathroom. Nevertheless, keeping some epoxy resin on hand for emergencies is a good idea.

Is your toilet leaking? Find out by putting some food color in the tank and then check the bowl later. If there is colored water in the bowl, the toilet has an internal leak. To fix an internal leak you can simply replace the tank's ball or flapper.

Before embarking on a plumbing project, make sure that you're aware of where the shutoff valve for water in your home is, as well as the valves for shutting off individual structures like sinks, toilets, etc. This way, if something goes wrong, you'll be able to stop the water flow.

Do not place items in the toilets that do not belong there. For example, if you are a female, do not throw away sanitary pads or tampons in your toilet. This could cause severe damage to your toilet that could require a plumber, or even worse, a whole new toilet!

Protect you plumbing pipes! If you live in an area which has cold winters and are leaving your home for an extended amount of time, protect your plumbing while you are gone! Shut off the main water valve! Drain the system of water by opening the faucets at the highest and lowest points of the house. Also, make sure that you have left some heat on in the house! Set the thermostat to at least 55 degrees Fahrenheit.

Check the plumbing in your home. If your home has the flexible gray polybutylene water pipes, you need to have a plumber come out and assess their condition. These types of pipe are prone to failure and can lead to very costly repairs if they have a failure within your home.

Be sure that you check on your water meter when it is not being used. Then, check on the meter 8 hours later. If the meter has changed, even a small amount, this could be a sign that there is an undetected water leak, which can be a severe problem.

Make sure hot water heater repair near me shut off your main system before leaving your house for a few weeks. The water will stay in the pipes, but this should prevent any further damages in case a leak starts while you are away. Check that your shut-off valve is working properly before you leave.

Keep an eye on the grout between tiles in your bathroom. Watch for cracks and areas where the grout seems to be falling out, and repair them immediately. Small grout crack issues can be easily repaired by pulling out the bad and putting in new grout. Allow any new grout to dry completely before exposing it to water.

Sticky substances like bananas, chicken skin and pumpkin pulp can clog your drain even if they go through the blades. Use the garbage can to store materials that the disposal can't handle.

If you need to locate a pipe under the floor, attach a strong magnet to a solid line coated with fish tape. Flush the magnet or throw it in a drain. Make sure to attach the line to something or to have someone hold it. Use a compass to locate the magnet and the pipe.

An important plumbing-related decision that must be made these days is the choice between an electric water heater or a gas water heater. In these times with gas costing as much as it does, it is more cost efficient to buy an electric water heater, especially if you have a smaller water heater.

If your pipes are made of copper, they might expand a little when hot water passes through them. This can often times lead to the pipes becoming warped, and not fitting tightly inside the pipe hangers, due to grinding. To avoid damaging your pipes, layer the ends of the pipe with tape to ensure that they will stay securely connected to the hanger.

So, now do you see why plumbing is such an exciting endeavor? Creating your own skills, learning to take care of your system, and being able to fix it yourself to save money is very exciting. The tips above should have created a good foundation for you to build upon and do your own plumbing jobs easily.